Caulking Concrete Cracks

Family Handyman

How to caulk wide gaps

Cracks and gaps in concrete are more than just an eyesore. Water can get into the joints, freeze and then expand, making the cracks even larger. Gaps against a house can direct water against the foundation, leading to more problems. Once a year, go around your home and fill these gaps and joints with urethane caulk to prevent problems. The expansion joint caulk is available at contractor supply stores, well-stocked home centers and hardware stores. For gaps and joints more than 1/4 in. wide, install foam backer rod to support the caulk. You want the rod to fit tight in the joint, so buy it one size larger than the gap.

A word of advice: Keep the urethane caulk off your bare hands and clothes; it’s the stickiest stuff you’ll ever touch. Wear disposable gloves when you’re tooling the joints. If you get some on your skin, quickly wipe it off with a paint thinner–dampened cloth.

Step One: Install Backer Rod

Use foam backer rod into the gap with your fingers. Set the rod 1/4 in. lower than the surface of the concrete.

Family Handyman

Step Two: Fill and smooth the joint

Fill the crack with urethane caulk, similar to what you would use for driveway caulk. It works perfectly as a concrete expansion joint sealant. Snip the opening of the tube at a 30-degree angle, making the opening the same size as your gap. Use a smooth, even motion, filling the crack flush with the surface, beveling it if it’s against the house. Smooth the caulk in wide joints with the back of an old spoon. Wipe the spoon clean as needed with a rag and mineral spirits.

Family Handyman

Step Three: Caulk Narrow Cracks

Caulk cracks 1/4 in. wide or less without using backer rod. Draw the gun down the crack, smoothing the caulk with the tip as you go.